Cambridge Audio A-BUS Table-Top Keypad Incognito BK10 - Manual (Page 9)

BK10 rear
Note: When using a BK10 keypad with an AH10 hub, an Incognito PS10 power
supply unit MUST be used.
Please consult the AH10 Incognito Multi-Room Installation Guide for full details
of the various options available for the full Incognito system.
Use a screw driver to carefully remove the backplate and set the mode switch to
the "AH10" position as shown below:
Note: Setting the mode switch to the wrong setting can cause erroneous
operation!
BK10 Table-top keypad
Incognito table-top keypad 9
IMPORTANT! The BK10 is default set to the A-BUS Ready/Incognito Ready
configuration. For use in a full Incognito system, the mode switch (located
inside the keypad block) must be set to the alternative “AH10” mode.