HONDA CRF50F - Manual (Page 113)

35 lbf·ft (46 N·m , 4.8 kgf·m)
105
Lubrication
Drive Chain
Servicing Your Honda
Turn the rear wheel by hand. Saturate each
chain link joint so that the lubricant penetrates
between the link plates, pins, bushings, and
rollers.
Lubricate every 300 miles (500 km) or sooner
if chain appears dry.
Turn the adjusting nuts ( ) on the right and
left chain adjusters an equal number of turns
to increase or decrease chain slack.
Align the chain adjuster index marks ( )
with the graduated scales ( ) on both sides
of the swingarm.
Torque the rear axle nut to:
If a torque wrench is not used for this
installation, see your dealer as soon as possible
to verify proper assembly.
Check rear brake pedal freeplay and adjust
as necessary (page
). Freeplay is affected
when repositioning the rear wheel to adjust
drive chain slack.
Recheck drive chain slack.
Tighten the adjusting nuts lightly. Then,
while holding the adjusting nuts with a
wrench, tighten the lock nuts.
3.
4.
5.
6.
7.
8.
4
3
5
88