Notes on learning function – Sony RM-Y130 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Notes on Learning Function
■ The LEARNING function does not work in VTRl or VTIL2
setting.
■ Do not move the remote commanders during learning.
■ If you press a button of this Remote Commander that cannot
be used for learning in learning mode, the LEARN indicator
flashes four times.
■ If the other remote control's signal cannot be learned, the
LEARN indicator flashes four times.
■ To clear all learned signals from memory, set the slide switch
inside the lid of this Remote Commander to MDP, press the
LEARN button, press the DSS POWER button while holding
down the VOL - button, then press the LEARN button
again.
■ Whenever you remove the batteries — to replace them, for
example — the code numbers revert to the factory settings
and must be reset.
1 0