Precautions – Sony PCGA-UMS1 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Additional information
Precautions
On safety
Should any solid object or liquid fall into
the casing, disconnect the USB mouse and
have it checked by qualified personnel
before continuing to use it.
On placement
Do not place the USB mouse in a location
where it is:
• On an unstable surface
• On the rug or carpet
• In very humid areas or where there is no
ventilation
• Subject to excessive dust
• Subject to direct sunlight or extreme heat
• Extremely cold
• In a car with the windows closed.
On operation
• If the USB mouse is brought directly
from a cold fo a warm location, or is
placed in a very damp room, moisture
may condense on the inside of the
mouse. Should this occur, the mouse may
not operate properly.
In this case, wait about 30 minutes for the
moisture to evaporate. If the mouse does
not operate properly after one hour,
please consult your nearest Sony dealer.
On cleaning the outside of the mouse
Clean the mouse with a soft, dry cloth or a
soft cloth slightly moistened with a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder, or solvent
such as alcohol or benzine.
On cleaning the inside (mechanism) of
the mouse
If there is dust or dirt inside the mouse
mechanism, the mouse does not work
optimally. To clean the mouse, follow these
steps.
1 Disconnect the mouse from the
computer.
2 Remove the mouse ball cover on the
bottom of the mouse.
3 Turn the mouse upright, and drop the
mouse ball into your hand.
4 Using a piece of adhesive tape, remove
any dust or dirt on the mouse ball and
inside the mouse ball socket.
5 Return the mouse ball to the socket, and
replace the mouse ball cover.
Mouse ball
On transportation
When you transport the mouse, fix the
mouse buttons in place by using the
supplied button holder as a stopper. Wrap
the connector cord around the mouse. You
can use the supplied wire clip to hold the
cord.
14“
Be sure to use the button holder when you
wrap the connector cord around the mouse.
Failure to do so may result in the mouse
buttons being out of order.
-