Sony PCGA-UMS1 - Manual (Page 16)

Specifications Troubleshooting
Interface
USB
Connector
USB Type A
Supported models
Sony "VAIO" notebook computers with
Windows 98
Length of the connector cable
Approx, 31 Vzin. (80 cm)
Operating temperature
41 T to 95 -F (5 "C to 35 ‘C)
Dimensions
Approx. 2V-*x2V-ix3'/8in.
(55 X 30.6 X 97.3 mm) (w/h/d)
Mass
Approx, 4 oz, (110 g) (mouse only)
Design and specifications are subject to
change without notice.
If you experience any of the following
difficulties while using the USB
mouse, use this troubleshooting guide
to help remedy the problem. Should a
problem persist, consult your nearest
Sony dealer.
My mouse does not work
□ The USB mouse is not connected
correctly.
- -) Close all applications, then
reconnect the USB mouse to your
computer.
□ The installation is not completed or
has failed.
•> Install the driver again (see page 7).
□ Windows 98 is not installed on your
computer.
-> Install Windows 98 as your
computer's operating system.
□ The USB root hub is not recognized.
-> Install Windows 98 correctly
again.
□ The USB port is not available.
•> In the Control Panel, double-click
the System icon. Under the Device
Manager tab, check that the USB
controller is enabled.
My wheel button does not work
□ A driver for a mouse that is
compatible with HID (Human
Interface Device) is installed on
your computer.
4 Remove this driver and install
the correct driver supplied on the
installation disk.
To remove the driver, follow
these steps.
1 Point to Settings on the Start
menu, and then click Control
Panel.
2 Double-click the System icon to
display the System Properties
dialog.
(continued) 15=