Sony SPP-A967 - Manual (Page 5)

step 2: Setting up the base unit (continued)
Notes
• Use only the supplied AC-T46 AC power adnptor.
Do not use an\ other AC power adaptor.
• Conneet the AC pov\ er adaptor to a eontinuous power
supply.
• Place the base unit close to the AC outlet so that you
can unplug the AC power adaptor easily.
Tips
• If your telephone outlet is not modular, contact your
telephone serxace company for assistance.
• Tr) remove the v\ all bracket, press the upper tab.
Polarity of the plug
Choose the dialing mode
For the telephone to work paroperly, select an appropriate dialing mode
(tone or pulse).
DIAL MODE switch
Depending on your dialing system, set the DIAL MODE switch as
follows;
If your dialing system is Set the switch to
Ttmo T
Pulse P
If you aren't sure of your dialing system
Make a trial call with the DIAL MODE switch set tc> T.
If the call connects, leave the switch ns is; otherwise, set to P.
8™ Getting Started
Step 3
Preparing the battery pack
Charge the battery pack for more than 12 hours before you start using
vour phone.
2
1
Slide open the battery
compartment lid of the handset.
Connect the battery connector
with correct polarity (black wire
goes on right side and red wire
goes on left).
Hook the cords and insert the
battery pack. Then close the lid.
Place the hanciset on the base
unit.
You can place either side facing
up.
The CHARCiE lamp lights up
when the handset is properly
seated on the charge terminals
ot the base unit. Charge the
battery- pack tor more than
12
hours so that the battery is fully
charged. The CHARGE lamp
remains lit even after charging
is completed.
continuel
Getting Started