Sony MZ-R55 - Manual (Page 21)

Editing recorded tracks
You can edit your recordings by adding/
erasing track marks or labeling tracks and
MDs. Premastered MDs cannot be edited.
Notes on editing
•Do not move or jog the recorder while “Toe
Edit”* is flashing in the display.
•You cannot edit tracks on an m D that is
record-protected. Before editing tracks,
close the tab on the side of the MD.
*TOC = Table of Contents
Erasing tracks
To erase a track
Note that once a recording has been
erased, you cannot retrieve it. Make sure
of the track you are erasing.
EDIT/ENTER
TMARK
Press EDIT/ENTER while playing
the track you want to erase.
” ■ Name” flashes in the display,
and the recorder plays the selected
track repeatedly.
To erase the whole disc
You can quickly erase all the tracks and
data of the MD at the same time.
Note that once a recording has been
erased, you cannot retrieve it. Be sure to
check the contents of the disc you want to
erase.
EDIT/ENTER
1
2
TMARK
Press EDIT/ENTER on the recorder.
Press or repeatedly until
”<S> : Erase” flashes in the display.
Press EDIT/ENTER again.
’’All Erase?” and ’’Push ENTER”
appear alternately in the display.
To cancel erasing, press ■ or
T MARK.
Press EDIT/ENTER again.
”Toc Edit” flashes in the display, and
all the tracks will be erased.
When erasing is complete, ’’BLANK
DISC” appears in the display.
Press or repeatedly until
Erase” flashes in the display.
Press EDIT/ENTER again.
’’Erase OK?” and ’’Push ENTER”
appear alternately in the display.
To cancel erasing, press ■ or
T MARK.
To erase a part of a track
Add track marks at the beginning and the
end of the part you want to erase, then
erase the part.
21