Record an md, To stop recording, press, If the recording does not start – Sony MZ-R55 User Manual
Page 7: Note
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
K'l
Record an MD.
© Press and slide REC to the right.
“REC” lights up and recording starts.
© Play the CD or tape you want to
record.
To stop recording, press ■.
“Data Save” or “Toe Edit” flashes while data
of the recording (the track’s start and end
points, etc.) is being recorded. Do not move
or jog the recorder or disconnect the power
source while the indication is flashing in the
display.
To
Press
Pause
II')
Press II again to resume recording.
Record from the end of the
previous recording
END SEARCH and slide REC.
Record partway through the
previous recoMing.
►,
or
to
find
the
start
point
of recording and press ■ to stop. Then
slide REC.
Remove the MD.
■ and open the lid.^’
A track mark is added at the point where you press II; thus the remainder of the track will be
counted as a new track.
Once you open the lid, the point to start recording will change to the beginning of the first track.
Check the point to start recording on the display.
If the recording does not start
• Make sure the recorder is not locked (page
20
) .
• Make sure the MD is not record-protected
(page 30).
• Premastered MDs cannot be recorded over.
Note
If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected)
when the recorder is operating, the lid will
not open until the power is restored.
V
•The level of the recorded sound is adjusted
automatically.
•You can monitor the sound during
recording. Connect the supplied
headphones with remote control to D/
REMOTE and adjust the volume by
pressing VOLUME
+/- (VOL +/- on the
remote control). This does not affect the
recording level.