Troubleshooting, If thin lines appear on your screen (damper wires), If out of scan range appears on the screen – Sony CPD-G500 User Manual
Page 17: On-screen messages, If no input signal appears on the screen, The input signai condition out of scan range, U the remedies, Q] the selected connector, 2] the input signai condition no input singal
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting
Before contacting technical support, refer to this section.
If thin lines appear on your screen
(damper wires)
The lines you are experiencing on your screen are normal for the
Trinitron monitor and are not a malfunction. These are shadows
from the damper wires used to stabilize the aperture grille and are
most noticeable when the screen’s background is light (usually
white). The aperture grille is the essential element that makes a
Trinitron picture tube unique by allowing more light to reach the
screen, resulting in a brighter, more detailed picture.
Damper wires
If OUT OF SCAN RANGE appears on the screen
On-screen messages
If there is something wrong with the input signal, one of the
following messages appears on the screen.
If NO INPUT SIGNAL appears on the screen
a>
I N K O R M A T I O N
M O N I T O R I S W O R K I N G
{ H D 1 5
N O I N P U T S I G N A L > -
W H I T E
a>
^ N I T O R I S W O R K I N G
W H I T E
[T]
The selected connector and the frequencies of the
current input signal
This message shows the currently selected connector
(HD 15 or BNC). If the monitor recognizes the frequencies of
the current input signal, the horizontal and vertical
frequencies are also displayed.
The input signai condition
OUT OF SCAN RANGE
This indicates that the input signal is not supported by the
monitor’s specifications.
[U The remedies
CHANGE SIGNAL TIMING appears on the screen. If you
are replacing an old monitor with this monitor, recormect the
old monitor. Then adjust the computer’s graphic board so that
the horizontal frequency is between 30 - 121 kHz, and the
vertical frequency is between 48 - 160 Hz.
For more information, see “Trouble symptoms and remedies” on
page 18.
Q] The selected connector
This message shows the currently selected connector
(HD 15 or BNC).
[2] The input signai condition
NO iNPUT SiNGAL
This indicates that no signal is input, or that no signal is input
from the selected connector.
17