Sony SPP-M920 - Manual (Page 17)

Receiving calls on the base phone
1
when you hear the phone ring,
press CuHlD or
(LINE2),
whichever LINE lamp is
flashing.
When you're done talking,
press
(OFF).
The LINE lamp goes off.
Additional tasks
To Do this
Put calls on hold Press (HOLD) to place all calls Mine 1. line 2. conference! on hold.
The line lamp blinks.
Press (
LINE 1 ) or ( LINE 2 ) to cancel hold on just one line.
Switch to another call*
on the same line
("call waiting" service) Press the LINE button for fhe current call to "FLASH" to the new
caller.
Press the LINE button again to return to the previous call.
Adjust the volume Press ( VOLUME +/-) until the desired level is reached.
Mute all calls Press C MUTE ) to disable the base phone microphone.
The MUTE lamp lights up.
Press ( MUTE ) again to cancel.
Turn the ringer on/off Activate the ringer for line 1 (LI RINGER) or line 2 (L2 RINGER) of
the base phone by setting the switches on the side of the base phone
to "ON" (ring) or "OFF" (silent).
n
fii
• You need to subscribe to this service with your telephone company.
To obtain the best speakerphone performance
• You may not be able to hear the other party's voice in a noisy place.
Therefore, use the speaker phone in a quiet room.
• Do not bring your hand or other objects too close to the microphone or you
will hear a shrill noise ("feedback").
• When the speaker volume is loud, or the telephone has been placed close to a
wall, you may find that the volume drops suddenly. This is due to a circuit in
the telephone designed to protect against feedback. In such cases, lower the
speaker volume slightly.
Note
The LINE lamp will also blink slowly when the handset or another extension is
in use.
If
Basics
I
17®