Sony SPP-M920 - Manual (Page 3)

SAVE THESE
INSTRUCTIONS
CAUTION:
To reduce the risk of fire or injurv’ to persons b\'
battery, read and follow these instructions.
1. Use only the following type and size battery’
pack; Sony BP-T23.
2. Do not dispose of the battery pack in a fire.
The cell may explode. Check with local
codes for possible special disposal
instructions.
3. Do not open or mutilate the-battery pack.
Released electrolyte is corrosive and may
cause damage to the eyes or skin. It may be
toxic if swallowed.
4. Exercise care in handling battery pack in
order not to short the battery with
conducting materials such as rings, bracelets,
and keys. The battery or conductor may
overheat and cause burns.
5. Charge the battery pack provided with or
identified for use with this product only in
accordance with the instructions and
limitations specified in the instruction
manual provided for this product.
6. Observe proper polarity orientation between
the battery^ pack and battery charger.
7. Do not mix old and new batteries in this
product.
8. Do not mix batteries of different sizes or from
different manufacturers in this product.
INFORMATION FOR
GENERAL TELEPHONES .
1. This equipment complies with Part 68 of the
FCC rules. On the bottom of this equipment
is a label that contains, among other
information, the FCC registration number
and ringer equivalence number (REN) for
this equipment. If requested, this
information must be provided to the
telephone company.
2. The applicable registration jacks (connectors)
USOC-RJ11C/RJ14C are used for this
equipment.
3. This equipment is designed to be connected
to the telephone network or premises wiring
using a compatible modular jack which is
Part 68 compliant.
The FCC compliant telephone cord and
modular plug is provided w'ith this
equipment,
4. The REN is used to determine the quantity of
devices which mav be connected to the
telephone line. Excessive RENs on the
telephone lino mav result in the devices not
ringing in response to an incoming call. In
most, but not all areas, the sum of the RENs
should not exceed five (5.0). To be certain of
the number of devices that may be connected
to a line, as determined by the total RENs,
contact the local telephone company.
5. If your equipment (SPP-M920) causes harm
to the telephone network, the telephone
company will notify you in advance that
temporary discontinuance of service mav be
required. But if advance notice isn't
practical, the telephone company will notify
the customer as soon as possible. Also, you
will be advised of your right to file a ■
complaint with the FCC if you believe it is
necessary.
6. The telephone company may make changes
in its facilities, equipment, operations or
procedures that could affect the operation of
the equipment. If this happens the
telephone company will provide advance
notice in order for you to make necessary'
modifications to maintain uninterrupted
service.
7. If trouble is experienced with this equipment
(SPP-M920), for repair or warranty
information, please contact Sony
Telecommunications Helpline: Tel 1-800-222-
7669. If the equipment is causing harm to
the telephone network, the telephone
company may request that you disconnect
the equipment until the problem is resolved.
8. All repairs will be performed in an
authorized Sony service station.
9. This equipment cannot be used to party lines
or coin lines.
10. This equipment is hearing aid compatible.
If your telephone is equipped
with automatic dialers
When programming emergency numbers and
(or) making test calls to emergency numbers:
1. Remain on the line and briefly explain to
the dispatcher the reason for the call.
2. Perform such activities in the off-peak
hours, such as early morning or late
evenings.