Sony KV-27S25 - Manual (Page 35)

MDP Manufacturer Code Numbers
Manufacturer Code number
MDP
Sony
701
Kenwood 707
Magnavox 703
Maranz 702
Mitsubishi 702
Panasonic 704
Philips 703
Pioneer 702
RCA 702
Sanyo 706
Sharp 705
Yamaha 703
Notes"
If more than one code number is listed, try entering them one
by one, until you come to the correct code for your equipment.
In some rare cases, you may not be able to operate your non-
Sony video equipment with the supplied remote commander.
This is because your equipment may use a code that is not
included with this remote commander. In this case, please use
the equipment's own remote control unit.
The code numbers for Sony equipment are assigned at the
factory as follows:
301 (preset code for the supplied
remote commander)
302
303
Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code number may
revert to the factory setting and must be reset.
VHS VCR
8 mm VCR
Beta, ED Beta VCRs
Operating video eqiripntent
VTR (POWER)
0-9 buttons
ENTER
CH +/-
Use the video operating buttons on the remote
commander to operate the video equipment.
Press VJR (FUNCTION) before operating the
video equipment.
Operating a VCR Buttons on the remote
commander
To turn on or off Press VTR (POWER).
To select a channel
directly Press the 0-9 buttons.
To change channels Press CH +/-.
To record Press ► while pressing •. First release
then release •.
To play Press ►.
To stop Press ■.
To fast forward Press
To rewind the tape Press -4^.
To pause Press II.
To resume normal playback, press again.
To search the picture
forward or backward Press ►► or during playback.
To resume normal playback, release the
button.
To change input mode Press TV/VTR.
Operating an MDP Buttons on the remote
commander
To turn on or off Press VTR (POWER).
To play Press the ►.
To stop Press ■.
To pause Press II.
To resume normal playback, press again.
To search the picture
forward or backward Keep pressing ►► or ◄◄ during playback.
To resume normal playback, release the
button.
To search the chapter
forward and backward Press CH +/-.
Note
• If the video equipment does not have a certain function, the
corresponding button on this remote commander will not
operate.
Turning off the system
■ KV-27V25I27V3SI29V35CI29V65MI29V75MI32V25I
32V35I34V3SCI35V35I35V45I35V75 only
You can turn off the TV and Sony equipment with the
S-Link function, such as a VCR, together when you
make the S-Link connection (see page 10 for the
connection).
Press SYSTEM OFF.
SYSTEM OFF
Operations
35