Sony KV-32V68 - Manual (Page 40)

Operating Cable Box or DBS Receiver
~
If the remote control doesn't work
Programming the remote
You can program the supplied remote control to
operate a cable box or DBS receiver.
1 Press CODE SET.
2 Press DBS/CABLE (EUNCTION).
3 Use the 0-9 buttons to key in the
manufacturer's code number from the
following chart.
4
Press ENTER.
For more details on operating the
cable box or DBS receiver
Refer to the operating instructions that were
supplied with the equipment.
• First, try repeating the setup procedures using
the other codes listed for your equipment.
Tips 'i'
•
If more than one code number is listed, try entering
them one by one until you come to the correct code for
your equipment.
•
If you enter a new code number, the code number you
freviously entered at that setting is erased.
•
In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment's supplied remote control.
•
Whenever you remove the batteries the code numbers
may revert to the factory setting.
Cable box code numbers
Manufacturer Code
Hamlin/Regal 222, 223, 224, 225, 226
Jerrold/G. 1. 201, 202, 203, 204, 205, 206,
207,208, 218
Oak 227, 228, 229
Panasonic 219, 220, 221
Pioneer 214,215
Scientific Atlanta 209, 210, 211
Tocom 216, 217
Zenith 212,213
DBS receiver code numbers
Manufacturer Code
Sony
801 (preset code for
remote control)
General Electric
802
Hitachi
805
Hughes
804
Panasonic
803
RCA/PROSCAN
802,808
Toshiba
806,807
36