Sony CMT-EX22 - Manual (Page 22)

Listening to the sound
of connected
components
1
Prepare the optional eomponents.
2
Press FUNCTION repeatedly until “PC/
TAPE” appears.
Each time you press the button, the function
display changes as follows:
TUNER —*• PC/TAPE
— CD«--------
□
To attenuate the distortion from
the connected components
You can change the audio input level for the PC/
TAPE input jacks between two levels.
If the sound from a connected component is
distorted, reduce the input level.
1 Press FUNCTION repeatedly until “PC/TAPE”
appears.
2 Press l/C!) to turn off the system.
3 While holding down ■ on the unit, press l/C!)
on the unit to turn on the system.
“ATT ON” appears in the display.
When the volume is too low, do steps I to 3 again
to reset to the original level.
Recording a CD on an
MD/a tape/a personal
computer
For the operations of the connected components,
refer to the instructions of each component.
2 4
1 Prepare the recording component for
recording.
2
Press FUNCTION repeatedly until
“CD” appears.
3
Start recording.
4
Press ►!!.
Play starts.
22