Sony CMT-EX22 - Manual (Page 8)

Step3: Presetting radio
stations
You can preset the following number of stations;
- 20 for FM, 10 for AM.
O O
'\-J w w
l/(!)
o o
'\^y
o o o
o o o
o o B
rA
©
©
© ® ® O
■©lESo-
o o o
o o o
1
3,4
4,6
6
5
1
Press l/(!) to turn on the system.
2
Press TUNER BAND repeatedly until
the band you want appears in the
display.
Each time you press the button, the band
changes as follows:
AM
3 Press PLAY/rUNING MODE
repeatedly until “AUTO" appears.
4 Press +/-.
The frequency indication changes and
scanning stops when the system tunes in a
station. “TUNED” and “STEREO” (fora
stereo program) appear. When you want to
stop scanning, press PLAY/TUNING
MODE.
O Press TUNING MEMORY.
A preset number flashes.
Proceed to step 6 while the preset number is
flashing. If the unit is not operated for more
than 16 seconds, the preset number
disappears and the unit returns to the status
of step 3. If this happens, start over from
step 4.
© Press +/- to select the preset number
you want then press ENTER.
The station is stored.
Select I to 20 for FM, and select I to 10 for
AM.
^ Repeat steps 2 to 6 to preset other
stations.
To tune in the station manually
1 Press PLAY/TUNING MODE repeatedly until
“MANUAL” appears in step 3.
2 Press +/- repeatedly to tune in the station and
continue from step 5.
To change the preset number
Start over from step 2.
To change the AM tuning
interval (except for European
model)
The AM tuning interval is factory-set to
9 kHz (10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first, then
turn off the power. While holding down the
TUNING + button on the unit, turn the power
back on. When you change the interval, all the
AM preset stations are erased. To reset the
interval, repeat the same procedure.
8