Additional information, Precautions, On safety – Sony CMT-EX22 User Manual

Page 24: On placement, On installing, On operation, On the speaker system, Notes on cds, Cleaning the cabinet

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Additional Information

Precautions

The nameplate is located on the bottom exterior.

On safety

• The glass over the display window on the cover is

made of tempered glass.
Under normal conditions, this tempered glass is
more shock resistant and able to bear more weight
than ordinary glass. This glass, however, may
shatter if it receives a sharp blow or if it is
scratched.

• The system is not disconnected from the AC power

source (mains) as long as it is connected to the wall
outlet, even if the system itself has been turned off.

• Unplug the system from the wall outlet if it is not to

be used for an extended period of time. To
disconnect the cord (mains lead), pull it out by the
plug. Never pull the cord itself.

• Should any solid object or liquid fall into the

system, unplug the system and have it checked by
qualified personnel before operating it any further.

• The AC power cord must be changed only at the

qualified service shop.

• When you connect the AC power cord to the wall

outlet (mains), even though the power is off, the
system begins charging for remote and timer
functions. Therefore the surface of this unit
becomes warm, this is normal.

On placement

• Make sure the system fan is on during use. Place the

system in a location with adequate air circulation,
and do not place anything on the system.

• Place the system in a location with adequate

ventilation to prevent heat build up.

• Do not place the system in an inclined position.
• Do not place the system in locations where it is;

— Extremely hot or cold
— Dusty or dirty
— Very humid
— Subject to vibrations
— Subject to direct sunlight.

On installing

When you move the system, remove the CD.

On operation

If the system is brought directly from a cold to a
warm location, or is placed in a very damp room,

moisture may condense on the lens inside the CD
player. Should this occur, the system will not operate
properly. Remove the CD and leave the system turned
on for about 2 hours until the moisture evaporates.

If you have any questions or problems concerning
your system, please consult your nearest Sony dealer.

On the speaker system

This speaker system is magnetically shielded and can
be used near TV sets. However, the picture on certain
TV sets may become magnetically distorted. In such a
case, turn off the power of the TV set once, and after

15 to 30 minutes turn it on again.

If there seems to be no improvement, locate the
speaker system further away from the TV set. Also,
be sure not to place objects in which magnets are
attached or used near the TV set, such as audio racks,

TV stands and toys. These may cause magnetic
distortion to the picture due to their interaction with
the system.

Notes on CDs

• Do not use a CD with tape, stickers, or paste on it as

this may damage the player.

• Before playing, clean the CD with a cleaning cloth.

Wipe the CD from the center out. Do not use
solvents such as benzine, thinner, commercially
available cleaners, or antistatic spray intended for
vinyl LPs.

• Do not expose the CD to direct sunlight or heat

sources such as hot air ducts, nor leave it in a car
parked in direct sunlight.

Cleaning the cabinet

Use a soft cloth slightly moistened with mild
detergent solution.

24

Advertising