Warning, Important, Caution – Sony STR-DE405 User Manual

Page 2: Note to catv system installer, Owner's record, Precautions, On safety, On power sources, On placement, On operation

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

WARNING

To prevent fire or shock

hazard, do not expose
the unit to rain or
moisture.

A

This svmbol fs intended to alert the user

to the presence of uninsulated

"dangerous voltage" within the

product's

enclosure that may be of sufficient

magnitude to constitute a risk of electric

shock to persons.

A

This symbol is intended to alert the user

to the presence of important operating

and maintenance (servicing)

instructions in the literature

accompanving the appliance,

IMPORTANT

rhis equipment has been tested and

found to comply with the limits tpr a

Class B digital device, pursuant to Part

Ih of the FCC Rules.

These limits are designed to provide

reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses, and can

radiate radio frequency energy and, if

not installed and used in accordance

with the instructions, may cause

harmful interference to radio

communications. However, there is no

guarantee that interference will not

occur in a particular installation. If this

equipment does cause harmful

interference to radio or television

reception, which can be determined by

turning the equipment off and on, the

user is encouraged to try to correct the

interference by one or more of the

following measures:

• Reorient or relocate the receiving

antenna.

- Increase the separation between the

equipment and receiver.

- Connect the equipment into an outlet

on a circuit different from that to

which the receiver is connected.

- Consult the dealer or an experienced

radio/TV technician for help

CAUTION
You are cautioned that any change or

modifications not expressly approved in

this manual could void vour authoritv

to operate this equipment.

Note to CATV system installer
This reminder is provided to call the

CATV system installer's attention to

Article 820-40 of the NEC that provides

guidelines for proper grounding and, in

particular, specifies that the cable

ground shall be connected to the

grounding system of the building, as

close to the point of cable entry as

practical.

Owner's record
The model and serial numbers are

located on the rear of the unit. Record

the serial number in the space provided

beloiA'. Refer to them whenever vou call

upon your Sony dealer regarding this

product.

Model No. STR-DE303/STR-DE405/

STR-D430Z/STR-D330Z

Serial No._________________________

Precautions

On safety

• Should any solid object or liquid fall

into the cabinet, unplug the recei\’er

and have it checked by qualified

personnel before operating it an\’

further.

On power sources

• Before operating the receiver, clieck

that the operating voltage is identical

with vour local power supply. The

operating voltage is indicated on the

nameplate at the rear of the receiver.

• The receiver is not disconnected from

the AC power source (.MAINS) as

long as it is connected to the wall

outlet, even if the receiver itself ha.s

been turned off.

• If you are not going to use the

receiver for a long time, be sure to

disconnect the receiver from the wall

outlet. To disconnect the AC power

cord, grasp the plug itself; never pull

the cord.

• C^ne blade <.)f the plug is wider than

the other for the purpose of safety

and will fit into the wall outlet only

one wav. If you are unable to insert

the plug fully into the outlet, contact

vour dealer.

• Should the AC power cord need to be

changed, have it done at a qualified

service shop only.

On placement
• Place the receiver in a location with

adequate \'entilalion to prevent heat

build-up and prolong the life of the

receiver.

• Do not place the receiver near heat

si>urces, or in a place subject to direct

sunlight, excessive dust or

mechaiiical shock,

• Do not place anything on top of the

cabinet that might block the

ventilation holes and cause

malfunctions.

On operation

• Before connecting other components,

be sure to turn off and unplug the

recei\'er.

On cleaning

• Clean the cabinet, panel and controls

with a soft cloth slightly moistened

with a mild detergent solution. Do

not use anv type of abrasive pad,

scouring powder or solvent such as

alcohol or benzine.

Advertising
This manual is related to the following products: