Sony CCD-TRV41 - Manual (Page 11)

To focus the viewfinder lens
If you cannot see the indicators in the viewfinder clearly, or after someone else has used
the camcorder, focus the viewfinder lens. Turn the viewfinder lens adjustment ring so
that the indicators in the viewfinder come into sharp focus.
Note on Standby mode
If you leave the camcorder in Standby mode for 5 minutes while the cassette is inserted,
the camcorder turns off automatically. This prevents wearing down the battery and
wearing out the tape. To resume Standby mode, turn STANDBY down and up again.
To start recording, press START/STOP.
Notes on recording mode
• This camcorder records and plays back in SP (standard play) mode and in LP (long
play) mode. The playback quality in LP mode, however, will not be as good as that
in SP mode.
• When a tape recorded on this camcorder in LP mode is played back on other types of
8mm camcorders or VCRs, the playback quality may not be as good as that on this
camcorder.
• If you select LP mode, then even if you are using a Hi8 tape, the camcorder records ir
the standard 8mm system. In this case, the Hi8 indicator flashes in the viewfinder or
on the LCD screen.
Note on recording
When you record from the beginning of a tape, run the tape for about 15 seconds befort
starting the actual recording. This will ensure that you won't miss any start-up scenes
when you play back the tape.
Notes on the tape counter
• The tape counter indicates the recording or playback time. Use it as a guide. There
will be a time lag of several seconds from the actual time. To set the counter to zero,
press COUNTER RESET.
• If the tape is recorded in SP and LP modes mixed, the tape counter shows incorrect
recording time. When you intend to edit the tape using the tape counter, record in
same (SP or LP) mode.