Chicago Electric 42933 - Manual (Page 13)

SKU 42933 For technical questions, please call 1-800-444-3353. Page 13
and secure the arm angle for various miter
positions. Positive index stops are 0, 15,
30, 45, and 60° (left and right). Non-index
stops can also be set within the range of
the arm assembly.
Yoke pivot- The Yoke Index Knob, located
at the top of the Yoke (under the Carriage
Arm) indexes the Yoke horizontally to 0°
(crosscuts) or 90° (for rip cuts). Loosen the
Yoke Pivot Clamp Handle and pull out the
Yoke Index Knob. Turn the motor assem-
bly until it locks at the index position. Lock
the Yoke Pivot Clamp Handle.
Blade Angle – The Bevel Index Knob (74)
and the Bevel Lock Knob (71) are used to
set the Blade angle (variable or indexed).
Loosen the Bevel Index Knob (71). Turn
the motor assembly clockwise or counter-
clockwise to the index notch of 0, 45, or
90°, or to a variable position without using
the index notch. Tighten the Bevel Lock
Knob by turning clockwise.
Depth of cut – The Elevating Handle
(100) at the rear of the arm is used to raise
and lower the height of the Saw Blade.
Turn the Elevating Handle clockwise to
raise the Saw Blade or counterclockwise
to lower it.