Chicago Electric 42933 - Manual (Page 16)

SKU 42933 For technical questions, please call 1-800-444-3353. Page 16
OpeRAtIOn
WARnIng: the Radial Arm Saw can be
very dangerous and cause serious
injuries if not operated properly.
Review all safety precautions be-
fore operating. keep hands out of
the path of the moving Saw Blade.
cross cutting
1. Secure the stock to be cut against the
table and fence.
If the stock length is short, do not
hold with your hand. Use a clamp to
hold in place.
Adjust the Anti-kickback Arm (13) so
2.
it just clears the stock.
Check that the Pivot Yoke Clamp
3.
Lock and Bevel Index Knob are set to
0° and are secure in place.
Adjust the Elevating Handle (100) so
4.
the Saw Blade (17) height is only 1/8”
into the worktable.
Push the Handle backward so that
5.
the Saw Blade is in behind the stock
to be cut.
Press the green Switch (122).
6.
Squeeze the Handle Trigger and
slowly pull the Handle toward you,
causing the Saw Blade to cut the
stock.
When the cut is complete, release the
7.
Trigger and push the Handle all the
way back.
Wait for the Saw Blade to stop turning 8.
before removing the stock.
Mitre cross cutting
1. Loosen the yoke Clamp Handle (66)
and pull out the Yoke Index Knob.
Turn the motor assembly to the left or
2.
right and lock the Yoke Index Knob at
45°.
Tighten the yoke Clamp Handle (66).
3.
Push the Handle backward so that 4.
the Saw Blade is in behind the stock
to be cut.
Secure the stock to be cut against the
5.
table and fence.
If the stock length is short, do not
hold with your hand. Use a clamp to
hold in place.
Adjust the Anti-kickback Arm (13) so
6.
it just clears the stock.
Press the green Switch (122). De-
7.
press and hold the Trigger in. Slowly
pull the Handle toward you, causing
the Saw Blade to cut the stock.
When the cut is complete, release the
8.
Trigger and push the Handle all the
way back.
Wait for the Saw Blade to stop turning
9.
before removing the stock.