Chicago Electric 42933 User Manual

Page 18

Advertising

SKU 42933

For technical questions, please call 1-800-444-3353.

Page 18

Slide the stock to be ripped into the

cutting area and verify that it slides

easily beneath the Safety Guard,

Anti-kickback Arm, and (optional)

Spreader Plate, and there is no

wobble space. Remove stock from

cutting area.
Press the green Switch (122),

10.

squeeze the handle Trigger (93) (mo-

tor starts), and push up on the Lock

On Button.
From the side of the machine, feed

11.

the stock into the Saw Blade (against

its rotation) using a (long) push stick.

WARnIng: Do not use your hand to

push the stock through the Saw

Blade. Do not reach around the

Saw Blade while it is running. Seri-

ous injury can occur to hands and

arms.
When the cut is complete, and before

12.

removing the stock, squeeze the Trig-

ger or pull down on the Lock On But-

ton, press the red Switch, and wait

until the saw blade stops completely.

Out-Rip cutting

Out-ripping is done when the in-rip posi-

tion will not permit a wide enough cut. This

function moves the Saw Blade to the front

of the machine. This operation is the same

as in-rip cutting (previously described),

with the exception that the Pivot Yoke is

turned so that the Handle is on the right

side of the machine (opposite of the in-rip

position).

Adjust the Saw Blade for In-rip cutting

as described on previous page.
Loosen the Bevel Lock Knob (71) and

pull out the Bevel Index Knob (74).
Turn the motor assembly clockwise

or counterclockwise, selecting the

desired angle (variable or indexed,

i.e., 45°).
Tighten the Bevel Lock Knob (71) and

push in the Bevel Index Knob (74).
Press the green Switch (122),

squeeze the handle Trigger (motor

starts), and push up on the Lock On

Button.
From the side of the machine, feed