Sony CMT-ED1 - Manual (Page 15)

Listening to the radio
— Preset Tuning
Before using this function, preset radio
stations in the tuner's memory (see "Step
3: Presetting radio stations").
POWER
VOL
+/-
1
Press FUNCTION repeatedly until
"FM" or "AM" appears.
2
Press FM or AM (or TUNER/BAND
on the remote repeatedly).
Press TUNING / PLAY MODE on
the remote repeatedly until
"PRESET" appears.
Press TUNING +/- (or KM/OOll
on the remote) to tune in the desired
preset station.
r-K..H
PRESET
TUNED ST
1 II 1 1 II
1 !!
U 1... "■
1 ! ! 1
....7^:““ 1
MHz
Preset Frequency
number
TO Do this
Turn off the radio Press POWER.
Adjust the volume Press VOLUME + /- (or
VOL + /- on the remote).
To listen to non-preset radio
stations
Press TUNING/PLAY MODE on the remote
repeatedly in step 3 until "MANUAL"
appears, then press TUNING +/- (or
ll<l<l/I>t>ll on the remote) to tune in the
desired station.
Tips
• Pressing TUNER/BAND on the remote while the
power is off automatically turns on the power and
tunes to the last received station (One Touch Play).
• You can switch from another source to the radio
just by pressing TUNER/BAND on the remote
(Automatic Source Selection).
• If an FM program is noisy, press STEREO/
MONO on the remote repeatedly until "MONO"
appears. There will be no stereo effect, but the
reception will improve. Press this button again to
restore the stereo effect.
• To improve broadcast reception, remove the rear
■ cover and put the antenna out of the cabinet (See
"To remove the AM antenna" on the page 6 ).
n
tt
w
o'
O
■D
ID
O
3
M
15