Playing a tape – Sony CMT-ED1 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Playing a tape
You can plav any typo of tape, TYPE I
(normal), TYPE II (CrO:) or TYPE IV (metal).
The deck automatically detects the tape type.
1
Press = PUSH of the front cover
and insert a recorded tape into deck.
With the side you want
to olav facing forward
18
2
Press FUNCTION repeatedly until
"TC" appears.
3
Press DIR MODE on the remote
repeatedly to select ~
" to play one
side or to play both sides.
4
Press O (or TAPE on the
remote),
Press <l (or TAPE <ll> on the remote
again) to play the rever.se side. The tape
starts playing.
The deck stops automatically after playing both
sides five times.
To
Do this
Stop play
Press □.
Pause
Press DO. Press again to
resume play.
Fast-forward
or rewind
During stop press , »OOfl
or IKKKKl {or <K]/[>C> on
the remote).
Find the beginning
of the current or
succeeding track
During play, press KKKKl
orl>Ot>t>lI (orlKKl/[>t>fl
on the remote).
Remove
the cassette
Press ^ PUSH.
Adjust the volume Press VOLUME +/- (or
VOL -t-/- on the remote).
Tips
• Pressing TAPE <!!> on the remote while the
power is off automatically turns on the power and
starts tape playback if there is a tape in the deck
(One Touch Play).
• You can switch from another source to the tape
deck just by pressing TAPE
on the remote
(Automatic Source Selection).
• When you want to reduce the hiss noise in low-
level high-frequency signals, press DOLBY NR on
the remote before step 4 so appears.