Sony STR-D711 - Manual (Page 31)

Problem Cause Solution
There is an abrupt loss of sound from
one or both of the speakers, and the '
PROTECTOR indicator flickers on the
display.
A short-circuit problem activates the
protective circuit.
Turn off the unit, eliminate the short-
circuit problem and turn on the power
again. If there is no short-circuit
problem, consult your nearest Sony
dealer.
Sound transmitted from the speakers
is reversed.
The speakers are not connected
correctly.
Connect the right speaker to the R
SPEAKER terminals and the left
speaker to the L SPEAKER terminals.
There is lack of bass sound or the ,
instrument position is obscure.
The ©/© connection of the speaker
is reversed.
Connect the speaker with the correct
phase.
Severe hum or noise is heard. The connecting cords are not shielded
type.
Use shielded type cords.
A transformer, motor, TV or fluorescent
light affects the connecting cords.
Place the connecting cords in a
location away from a transformer or
motor, and at least 3 meters (10 feet)
from a TV set or a fluorescent light.
The audio components are too close
to a TV set.
If both are used at the same time,
separate the TV from the audio
components.
The unit is not grounded. Connect the ground wire to the
antenna ground terminal.
■
The connections are loose. Make secure connections.
■ The plugs and jacks are dirty. Wipe the plugs and jacks with a cloth
lightly dampened with alcohol.
Surround effect cannot be obtained. The unit is in a wrong mode. Press CURSCR MCDE to set the
surround mode.
■
The SOUND FIELD circuit is turned
off.
Press SCUND FIELD CN/CFF.
The remote commander \will not
operate.
The batteries are exhausted. Replace the batteries with new ones.
The commander head is not pointed
toward the unit's front.
Point the commander head toward the
receiver.
The equipment cannot be operated. The mode of the receiver is not same
with that of the remote commander.
Press the desired FUNCTICN button
again.
31