Sony MDS-M100 - Manual (Page 20)

3Q
«
n
O
a
3 '
in
0
3
S
Q
Synchro-recording With a Sony CD Player
(CD Synchro-recording)
Operations you may want to do during CD
Synchro-recording
To Press
Stop recording CD-SYNC STOP
Pause recording CD-SYNC STANDBY or CD
PLAYER
II
Locate the next track to be
recorded during recording
pause CD PLAYER
Resume recording after CD-SYNC START or CD
pausing PLAYER II
Check the remaining
recordable time on the MD DISPLAY (page 12)
9 You can use the remote of the CD player during CD Synchro­
recording
Press To change the deck to And change the CD player to
0 Recording Play
■ Recording pause Stop
II Recording pause Pause
? During CD Synchro-recording, track numbers are marked in
the following ways:
• When the CD player is connected to the DIGITAL IN connector,
track numbers are automatically marked as thev appear on the
CD.
• When the CD player is connected to the LINE (ANALOG) IN
jacks, track numbers are automatically marked when "T.Mark
LSync" has been selected (page 17).
• When you resume recording after recording pause, a new track
number is automatically marked, regardless of the track
marking parameter setting ("T.Mark LSync" or " T.Mark Off").
? You can change CDs during CD Synchro-recording
1 Press ■ on the CD player's remote.
2 Change the CD.
3
Press C> on the CD player's remote.
Recording resumes.
9 You can also perform synchro-recording with a Sony video
CD player
By reprogramming the MD deck's remote, you can use the
procedure above to perform Synchro-recording with a Sony
video CD player.
Press number button 2 while pressing down
l/(!) on the MD
deck's remote. You can now operate the MD deck and the video
CD player with the remote. To control the CD player again, press
number button 2 while pressing down l/C!) on the MD deck's
remote.
Notes
• When performing CD Synchro-recording with a CD player
with a mode selector, be sure to sot the selector to CDl.
• Wlien \'ou record tracks from certain CD or multi-disc players,
the entire material may be recorded as a single track.
2 0