Antenna hookups, Fm outdoor antenna, Overview – Sony STR-D965 User Manual
Page 5: Hookups, Am loop antenna, Q if you have poor am reception, Connecting a ground wire, Audio component hookups, Getting started, Where do i go next
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting Started
Antenna Hookups
FM outdoor antenna
insulated wire
Overview
This section describes how to connect AM and FM
antennas to the receiver. If you want to receive radio
broadcasts with the receiver, complete these
connections first, then go to the following pages.
For specific locations of the terminals, see the
illustration below.
ANTEMNA
FM wire antenna
(supplied) (1)
AM loop antenna
(supplied) (1)
Hookups
FM wire antenna
Receiver
AM loop antenna
'Q' If you have poor FM reception
Connect a 75-ohm coaxial cable (not supplied) to an FM
outdoor antenna.
Q If you have poor AM reception
Connect a 20 to 50 ft. (6 to 15-meter) insulated wire (not
supplied) Fo the AM antenna terminal in addition to the
AM loop antenna. Try to extend the wire outdoors and
keep it horizontal.
Connecting a ground wire
To prevent hum, connect a ground wire (not supplied)
to the ih ground terminal. If you've connected an
outdoor antenna, be sure to connect the ground for
lightning protection.
Receiver
I
♦
to ground
Where do I go next?
If you want to connect other components, go on to the next
section. If you're only planning to use the receiver to listen
to the radio, go to "Speaker System Hookups" on pages 6
and 7.
Audio Component Hookups
Overview
This section describes how to connect your audio
components to the receiver. If you want to use the
receiver as an amplifier, complete these connections.
For specific locations of the jacks, see the illustration
below.
TAPE