Sony CDP-C910 - Manual (Page 10)

Playing a Disc - Continuous Play
During stop
slot number where Total number of selections
the disc is
in the disc
clamped currently
Information Display
Choose a disc to play with the DISC selectors. If you
press ■ while the bar under the disc number is blinking,
the total number of selections and total playing time will
appear after the bar stops flashing. In a few seconds, the
display will change and show the disc number or if there is
one, the disc memo. This display sequence is also
available when using the DISC SKIP. When the DISC SKIP
button is pressed the disc number or, if applicable, the
disc memo will appear until that disc is set.
To activate this display sequence while the disc number or
disc memo is being shown, press the TIME/MEMO button.
□
: mo I
in a selection
I TIME^EMO t
If you press TIME/MEMO during play, the display changes
to give you the following information:
□ Elapsed playing time of the selection. It automatically
displayed when play begins.
n Remaining time in a selection. Selection numbers up
to 20 are also displayed at the bottom of the display
window.
If the track number is iarger than 20, appears
insted of the remaining time display.
□ Remaining time and remaining selections of the disc
(displayed only in the continue mode).
When the time fade function is activated, remaining
time and remaining selections until the fading out will
be displayed.
13 Disc memo or disc number.
Notes
• Total remaining time is only available during continuous mode. It
will not be displayed by pressing the TIME/MEMO button during
program, bank or shuffle mode.
• Total remaining time will be displayed, if time fade is set during
all play mode.
10