Sony SPP-A700 - Manual (Page 43)

Symptom Remedy
The handset doesn't ring when
calling troni the base unit. Set the RING ON /OFF switch to ON.
N oil can't hear anything trom
the speaker.
U)
c
Use the STEAKFR VOLUME control tm the base unit
to increase the speaker volume.
No time stamp is heard. Make sure the day and time are set (page 23).
The day and time may have been cleared due to a
power interruption. Set them again (page 23).
You can't record the greeting
properly. Keep vour message between two seconds and four
minutes.
Make sure you speak about 12 inches (30 cm) away
from the microphone when recc'rding.
S The phone does not record Check the answering mode. The phone cannot record
messages in ANN ONLY mode.
Make sure that the memory is not full. When the
remaining recording area is less than one minute, the
phone switches to ANN ONLY mode automatically.
The phone doesn't record a message that is shorter
than two seconds.
Even if the message is longer than four minutes, the
phone only records up to four minutes.
E g
2 i
Q.
.£ "D
The phone doesn't accept your
security code. Make sure you call from a touch-tone phone.
Make sure you entered vour security code within twin
seconds after you've entered
CM3-
You hear error beeps when you
enter your security code. Make sure the security code is correct.
ra
Q. O
O
<u A long confirmation beep
doesn't sound when you enter
your security code. Enter your security code while the greeting is being
played back.
Make sure you are calling from a touch-tone phone.
The caller's name and/or
phone number does not appear
on the display.
10
u
Make sure you have subscribed to Caller ID service.
Caller ID service may not work when the phone is
connected to a Private Branch Exchange (PBX).
The call is made through company which does not
offer Caller ID service. "OUT OF ÀREA" will appear
on the display.
The call was "blocked." "PRIVATE" will appear on
the display.
You answered the call while "t*RINGING^>l:"is
displayed. Be sure to answ'er after the Caller ID data
i s
displayed.
The caller's name and/or
phone number docs not appear
on the display during call
waiting. Make sure you have subscribed to "Caller ID with call
waiting" service (see page 38).
Make sure nobody is talking on another phone on the
same telephone line.
>
Q.
Q.
0
3
at
o
3
at
5'
3
continued
Additional Information 43