Sony SPP-A700 - Manual (Page 44)

Troubleshooting (continued)
Symptom Remedy
You cannot dial the number
from the Caller ID list.
Make sure vou entered your area code correctly
(page 13).
This function ma\’ not work when the phone is
connected to a Private Branch Pxchange (PBX).
<0
U
The memory match function
does not work. If the call is from an office which uses multiple lines,
the phone number may not match the number you
put in the memory.
If you stored the pihone number with an outside line
access digit in the Phone Directory because the phone
IS connected to a Private Branch Exchange (PBX), the
phone number will not match the Caller ID ciata.
<v
e
nj
The CHARGE/IN USE lamp
doesn't light up when you
place the handset to charge.
Wipe the charge terminals of the base unit and the
handset with a soft cloth or paper for better contact of
the charge terminals.
Make sure the handset is placed on the base unit
properly.
01
5
o
Q.
in The battery duration is short. The battery pack was charged less than 12 hours (due
to power failure, etc.).
The usable life of the battery has expired and needs
replacement.
Counter message
The message counter on the base unit shows the following information.
When the counter shows It means
Number (0-19) Number of messages not yet played back. The counter
shows up to 19 messages. After that, "19" flashes to tell
you that there are 20 or more messages.
P Flashes when the day and time is cleared due to a power
interruption, or when you connect the base unit to the
AC outlet for the first time.
A The announcement only mode is selected (page 26).
F The recording area is full. Erase unnecessary messages
(page 27).
44" Additional Information