Running a system test, To run the system test, Run system test – Sony SAT-A2 User Manual
Page 75
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Running a System Test
If The System Test Reports
Any Problems...
The System Test lets you check the integrity of your system’s
components, including;
□ Antenna signal
□ System tuning
□ Phone line
□ Access card
Use the System Test if you are experiencing problems with your
system.
To run the System Test:
1
Select SYSTEM TEST from the Setup Menu.
2
Select TEST.
RUN SYSTEM TEST
SIGNAL
TUNING
PHONE
CARD
RETURN
HELP
The System Test checks all the components automatically, and
displays the result of each test.
3
Select RETURN to return to the Setup Menu.
Check your system for any of the following:
□ The access card test will fail if you have not yet called your
program providers to establish service. After your service has been
established, the access card test should pass-.
□ Check that all cables are connected properly to the DSS receiver.
□ Check that the satellite antenna is installed correctly, and that the
signal has been optimized. See the manual that came with the
satellite antenna for details.
□ Check that the phone line connected to the DSS receiver is working
properly.
□ Check that the access card is inserted properly.
If you cannot resolve problems reported by the System Test, see
"Customer Support" on page 2.
Chapter 6: Using the Setup Menu 75