Sony KP-41T25 - Manual (Page 41)

Operating a cable
box
You can operate a connected cable box with the
supplied remote commander. Before operating, set the
manufacturer's code number.
MODE
Low position
1
Set the CABLE BOX/TV selector to CABLE
BOX.
CABLE BOX. .TV
While holding down CODE SET, press 0-9
to enter the manufacturer's code number
(see the chart in the right column) and
press ENTER. For example, to operate a
Zenith cable box, press 6 and 8 and press
ENTER.
+ ci>
3
Use POWER (CABLE) and the projection TV
control buttons (0 - 9, ENTER, JUMP and CH
+/-) to operate the cable box.
-POWER
ID
o © ©
© © ©
JUMP
To operate the projection TV
Set the CABLE BOX/TV selector to TV. Then use the
projection TV control buttons to control the projection
TV.
For more details on operating the cable box
Refer to the operating instructions that come with the
cable box.
Manufacturers and code numbers (cable box)
Manufacturer Code number
JERROLD 60, 61, 62, 63, 64, 65, 73
PIONEER 69, 70
SCIENTIFIC ATLANTA 66, 67
TOCOM 71,72
ZENITH 68
Notes
• If more than one code number is listed, try entering them one
by one until you come to the correct code for your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some rare cases, your equipment may use a code that is not
provided with this remote commander and you may not be
able to operate your cable box with the supplied remote
commander. In this case, use the equipment's own remote
control unit.
• When you remove a battery from the remote commander, the
code may be erased. Reset the code each time you replace the
battery, if necessary.
Operations ^'j-EN