Attaching the fence to the table {fig. 6), To attach the miter gauge (fig. 7), Mounting the table to a work surface (see fig. 8) – Craftsman 320. 28180 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ATTACHING THE FENCE TO
THE TABLE {Fig. 6)
A
WARNING; Always
unplug the router before at
taching or removing the fence.
The fence has been shipped
completely assembled.
1. Place the fence assembly
on the table with the four
wing nuts facing toward you.
2. Align the two holes on the
bottom of fence assembly
with the two channels on
the router table.
3. Secure the fence to the
table with two clamping
knobs (5), two plain washers
(11), and two short, round
head, square-neck bolts (6).
TO ATTACH THE MITER
GAUGE (Fig. 7)
The miter gauge has been
shipped completely assembled.
Attach the miter gauge to the
table by placing the miter-gauge
bar in the slot on the table.
MOUNTING THE TABLE TO
A WORK SURFACE (See Fig. 8)
1. Place the router table, up
right, on a sturdy surface,
e.g., work stand, work
bench, or counter top.
2. While holding the router
table in place, mark on the
work surface the location
of the two mounting holes
(11/32-in dia.) in each of
the legs.
3. Remove the router table.
281S0 ManuaLF?evised„07-0228
Page 16