How to stop your cleaning system, How to use the adjustable nozzle, A caution – Craftsman 580.767451 User Manual
Page 10: Cleaning with the adjustable nozzle, Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
How to Stop Your Cleaning System
• Move throUia iever to
“Stop”
position.
• Squeeze trigger on the spray gun to relieve
pressure in the hose,
NOTE:
A small amount of water will squirt out when
you release the pressure.
• Rotate the Dial-A~Cleaner™ selector knob to the
OFF position to prevent chemical leakage.
How To Use the Adjustable Nozzle
Now that you know how to
START
and
STOP
your
pressure washer, the information in this section will tell
you how to adjust the spray pattern and apply
detergent or other cleaning chemicals.
3.
A
CAUTION
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
•: NEVER adjust spray pattern when spraying. ; : : : : :
. : NEVER put hands in frönt of nozzie to adjust spray pattern.
Your unit is equipped with an adjustable nozzle that
permits you to adjust the spray pressure and the spray
pattern, as follows:
1, Push nozzle forward (backward) to adjust spray
pattern for high (low) spray pressure.
2, Point nozzle toward ground, disengage safety
latch, and press trigger to test pattern.
Twisting nozzle adjusts spray pattern from a
narrow pattern to a fan pattern.
from 8 to 24 inches away from cleaning surface.
If you get spray nozzle too close, especially using
high pressure mode, you may damage surface
being cleaned.
DO NOT get closer than 6 inches when cleaning
tires.
Cleaning With The Adjustable Nozzle
6.
CAUTIONl Before starting your cleaning system,
make sure you have read and followed the instructions
in the sections “Assembling your Cleaning System”
and 'To Start your Cleaning System”.
IMPORTANT; Use chemicals designed specifically
for pressure washers.
Househoid detergents ojuid
damage the pump.
CAUTION
You must attach a
I!
hoses before you start the engine.
Si^rting the: engine without all the hoses connected and
without the water turned ON will damage the pump.........
Up to three (3) different solutions can be carried with
the cleaning system at one time. To apply detergent
follow these steps:
1. Dilution is necessary when using supplied chemicai
packets. Simply snip one corner of plastic pouch,
pour chemical into tank, then fill tank with clean
water. Label tanks with provided tank labels.
10