Craftsman 113.2472T0 - Manual (Page 11)

ASSEMBLING CABINET
Model 113.247310
1. Separate all “loose” parts from packing materials
and check each item with “Parts List” to make
sure all items are accounted for before discard­
ing any packing material.
From loose parts find the foliowing items;
ITEM DESCRIPTION QTY.
1 Right Side Panel .................................... 1
2 Left Side Panei........................................ 1
3 Lower Shelf............................................. 1
4 Skirt.......................................................... 2
5 Shelf Stiffener.......................................... 1
6 Corner Bracket........................................ 2
7 Spacer..................................................... 2
From loose parts bag find the foliowing hardware:
ITEM DESCRIPTION QTY.
A Screw, Truss Head 1/4-20
X
1/2............. 34
B Lockwasher Ext. 1/4.............................. 34
C Nut, Hex 1/4-20...................................... 34
D Foot Leveling ......................................... 4
E Hex Nut 3/8-16........................................ 8
R Cover...................................................... 2
2, After layout of cabinet parts, take the lower shelf
and turn upside down on floor. Small front flange
should be pointing upward.
3. Locate the two (2) corner brackets, four (4) 1/4-
20 X 1/2 truss head bolts, lockwashers, and nuts.
Attach the corner brackets to the front flange in
holes as illustrated. Attach both corner brackets.
Locate the two (2) side panels, one (1) shelf
stiffener, and six (6) 1/4-20x 1/2 truss head bolts,
lockwashers and hex nuts. Place the right side
panel on its back side as iilustrated. Stand up the
lower shelf on the rear flange and line up the
holes on the corner bracket and shelf stiffener
with the holes in the side panel. Mount the bolts
in the three holes and tighten hex nuts with a
7/16-inch wrench or socket. Repeat procedure
for left side panel.
11