Installing the blade – Craftsman 113.2472T0 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLING THE BLADE
1. Remove the blade guard by loosening the two (2)
mounting screws with a phillips screwdriver and
lifting the blade guard upward.
2. Loosen the upper blade guide assembly and
lower to approximately 3 inches above rear table
and retighten lock knob. This is necessary to
make adjustments to blade guide and back up
roller bearing.
3. Loosen the two capscrews that lock the upper
blade guides using a 1/8-inch hex “L” wrench
and separate them about 1/8-inch. Repeat the
same step for the lower blade guides.
BLADE
GUIDE
CAPSCREWS
BLADE
GUIDE
CAPSCREWS
Loosen the setscrew which locksthe bladeguide
support and push the support all the way back.
Repeat for lower blade guide support.
UPPER BLADE
GUIDE SUPPORT
SETSCREW ------------------------