Assembl – Craftsman 315.284620 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBL
i
I
RED
INDICATOR
VSLOT
Fig. 6
Fig. 7
MOUNTING THE TABLE SAW BASE TO THE
LEG STAND
See Figure 8.
■ Place the table saw base on the leg stand. Position the
locking knob over the holes in the top of the leg stand.
■ Insert the screw on the locking knob into the hole and
turn the locking knob clockwise to secure the table saw
base to the leg stand.
■ Repeat with the other three locking knobs.
LOCKING
KNOB
Fig. 8
TO INSTALL THE HANDLE
See Figure 9.
■ Hold the nylon nut securely and turn the screw
counter- clockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle.
■ Place the nylon nut into the recessed hole on the back
of the height/bevel adjusting handwheel and hold in
place.
■ Slide the handle and screw into the hole on the
height/bevel adjusting handwheel.
■ Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
16