Cabletron Systems 6H129-08 - Manual (Page 120)

Chapter 5: Local Management
5-74 6H128-08 and 6H129-08 User’s Guide
Peak Switch Utilization (Read-only)
Shows the peak percentage of maximum switching capacity, since last
reset.
Reset Peak Switch Utilization (Toggle)
Allows the user to reset the Peak Switch Utilization field. The switch may
be set to either YES or NO as described in
Section 5.21.1 . YES resets the
Peak Switch Utilization field to the current system traffic.
5.21.1 Setting the Reset Peak Utilization
To set the Reset Peak Utilization field to YES or NO, proceed as follows:
1. Use the arrow keys to highlight the Reset Peak Switch Utilization
field.
2. Press the SPACE bar to select YES or NO.
3. Use the arrows keys to highlight the SAVE command at the bottom of
the screen.
4. Press ENTER. The message “SAVED OK” is displayed.
5.22 FLASH DOWNLOAD SCREEN
The Flash Download screen, shown in Figure 5-28 , allows the user to
clear the information stored in the 6H12X-08 FLASH memory and
download a new image file from a TFTP server.
Before downloading a new image to the module, load the image onto the
network TFTP server.
NOTE
The user may also force a download by changing the position
of Switch 6 located inside the module. Refer to
Section C.2 for
details.
NOTE
For information on how to set up a workstation as a TFTP
server, refer to the specific workstation documentation.