Installing nozzle/curved tube, Removing the blower tube – Craftsman 316.794830 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTIONS
ASSEMBLING UNIT
Installing Blower Tube
3. Twist the nozzle clockwise over the blower tube until tight (Fig. 4).
A
WARNING:
To prevent serious personal injury, stop
the engine and allow the impeller to stop before attaching
or removing tubes.
A
WARNING:
To prevent serious personal injury or
damage to the unit, the blower tube must be installed
while operating this unit.
1. Align the bump on the end of the blower tube with the bump
slot on the bottom end of the blower outlet (Fig. 1).
2.
Insert the bump on the blower tube into the bump slot on the
blower outlet (Fig. 1).
3.
Twist the blower tube clockwise inside the blower outlet until the
bump locks into place (Fig. 2).
Installing Nozzle/Curved Tube
1. Align the bump on the end of the blower tube with the bump
slot on the bottom end of the blower outlet (Fig. 3).
2.
Insert the bump on the blower tube into the bump slot on the
nozzle (Fig. 3).
Removing the Blower Tube
1.
Hold the unit firmly.
2.
Insert a flathead screwdriver into the Tube Lock. Twist the
screwdriver counterclockwise 1/4 turn and hold it there (Fig. 5).
3.
While holding the screwdriver in a counterclockwise position,
grasp the blower tube and twist it counterclockwise (Fig. 5).
4.
Pull the blower tube from the blower outlet.
Removing the Nozzle/Curved Tube
1.
Hold the blower tube firmly.
2.
Grasp the nozzle and twist it counterclockwise until the nozzle
unlocks from the blower tube (Fig. 6).
3.
Remove the nozzle from the blower tube.