Craftsman 316.794830 - Manual (Page 7)

OIL AND FUEL INFORMATION
WARNING: OVERFILLING OIL ORANKOASE MAY
OAUSE SERIOUS PERSONAL INJURY. Oheck and
maintain the proper oil level In the crank case; It Is
Important and cannot be overemphasized. Oheck the oil
before each use and change It as needed. See
Changing the Oil.
RECOMMENDED OIL TYPE
Using the proper type and weight of oil In the crankcase Is
extremely Important. Oheck the oil before each use and change the
oil regularly. Failure to use the correct oil, or using dirty oil, can
cause premature engine wear and failure.
Use a high-quality SAE 30 weight oil of API (American Petroleum
Institute) service class SF, SG, SH.
ADDING OIL TO CRANKCASE: INITIAL USE
NOTE: This unit Is shipped without oil. In order to avoid damage to
the unit, put oil In the crankcase before you attempt to start
the unit.
Your unit Is supplied with one 2.03
fluid oz. (60 ml) bottle of SAE 30 SF,
SG, SH oil (Fig. 7).
NOTE: Save the empty oil bottle. It
can be used to measure the
correct amount during future
oil changes. See Changing the
ON.
1. Unscrew the top of the bottle of oil
and remove the paper seal
covering the opening. Replace
the top. Next, cut the tip off the
funnel spout (Fig. 7).
2. Tip unit so that the back of the
engine Is facing up In a vertical
position.
3. Remove the oil fill plug from the
crankcase (Fig. 8).
4. Pour the entire bottle of oil Into
the oil fill hole (Fig. 9).
NOTE: Never add oil to the fuel or
fuel tank.
5. Wipe up any oil that may have
spilled and reinstall the oil fill
plug.
Check oil before each use and
change as needed. Refer to
Checking the OH Level.
RECOMMENDED FUEL TYPE
Old fuel Is the primary reason for
Improper unit performance. Be sure to use fresh, clean, unleaded
gasoline.
NOTE: This Is a four cycle engine. In order to avoid damage to the
unit, do not mix oil with gasoline.
Definition of Biended Fueis
Today's fuels are often a blend of gasoline and oxygenates such as
ethanol, methanol or MTBE (ether). Alcohol-blended fuel absorbs
water. As little as 1 % water In the fuel can form acids when stored.
Use fresh fuel (less than 60 days old), when using alcohol-blended
fuel.
Using Biended Fueis
If you choose to use a blended fuel, or Its use Is unavoidable, follow
recommended precautions:
• Always use fresh unleaded gasoline
• Use a gas stabilizer fuel additive
• Drain tank and run the engine dry before storing unit
Using Fuei Additives
The use of a gas stabilizer will inhibit corrosion and minimize the
formation of gum deposits. Using a fuel additive can keep fuel from
forming harmful deposits in the carburetor for up to six (6) months.
Add 0.8 oz. (23 ml.) of fuel additive per gallon of fuel according to
the instructions on the container. NEVER add fuel additives directly
to the unit's gas tank.
FUELING THE UNIT
A WARNING: Add fuel in a clean, well ventilated
outdoor area. Wipe up any spilled fuel immediately.
Avoid creating a source of ignition for spilt fuel. Do not
start the engine until fuel vapors dissipate.
A WARNING: Gasoline is extremely flammable. Ignited
vapors may explode. Always stop the engine and allow it
to cool before filling the fuel tank. Do not smoke while
filling the tank. Keep sparks and open flames at a
distance from the area.
Fig. 10
2 . Place the gas container’s spout into the fill hole on the fuel tank
(Fig. 10) and fill the tank.
NOTE: Do not overfill the tank.
3. Wipe up any gasoline that may have spilled.
4. Reinstall the fuel cap.
5. Move the unit at least 30 ft. (9.1 m) from the fueling source and
site before starting the engine.
NOTE: Dispose of the old gasoline in accordance to Federal, State
and Local regulations.