Country Home Products DR - Manual (Page 17)

DR  COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions 13
Tilt Bed Installation
The following procedure includes all of the steps necessary for the installation of the Tilt
Bed on the DR LEAF and LAWN VACUUM.
Note: The plastic Tilt Bed is mounted loosely on the frame to allow for expansion of the
plastic.
1. Place the Tilt Bed on the trailer frame with the mating hinges at the same end.
Tip: Block the wheels to keep the machine from rolling away.
2. Align the left hinge on the Tilt Bed with the left hinge on the trailer frame (Figure 7).
3. Insert a Clevis Pin through the mated hinges and secure with a Hitch Clip (Figure 7).
Tip: Tilt the bed back for ease of inserting the Clevis Pins.
4. Repeat Step 3 for the right side hinges.
5. Lower the Tilt Bed, using the Dump Handle, to the down position and make sure that
the Dump Lever locks into place before proceeding with the Collector Box installation
(Figure 8). The Dump Lever is spring loaded so it will click into the Locked Position
when the Tilt Bed is all the way down.
Figure 7
Figure 8
Hitch Clip
Trailer
Frame
Tilt Bed
Hinge
Clevis Pin
Locked Position
Dump Handle