Country Home Products DR - Manual (Page 18)

14 DR  COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions
Collector Box Installation
The following procedure includes all of the steps necessary for the installation of the Collector
Box on the DR LEAF and LAWN VACUUM.
1. Place the projecting edges of the two Side
Panels in the slots on the trailer as shown.
Note: The Side Support plates are loosely
mounted to the Side Panels to allow for
easy alignment and expansion of the
plastic. Align the holes in the projecting
edges with the holes in the trailer
frame. Secure them at each end to the
trailer frame with the 5/16" x 2" Wing
Screws. Install a Lock Washer followed
by a Flat Washer on each Wing Screw.
The Wing Screws are inserted through
the frame from the outside (Figure 9).
Note: The side support plates may have swung
inside during shipping.
2. Tip the Centrifugal Separator at a 45° angle
and slide it between the secured sides on the
trailer
with the hose protruding along the
right side of the trailer pointing toward the
front (Figure 10).
3. Place the left edge of the Centrifugal
Separator on top of the left side panel.
(Figure 10).
Tip: This can be accomplished easier with two
(2) people.
4. Lift the hose side of the Centrifugal
Separator and place it on top of the right
side panel; align the holes in the top edges
of the side panels with the protruding pins
from the Centrifugal Separator and secure in
place with the flexible latches (Figure 11).
Tip: Push out in the middle of the top of the
side panel to help seat the pin in the hole
in the middle of the top edge of the Side
Panel.
Figure 9
Figure 10
Panels
Inserted
in Slots
Figure 11
Pin in
Hole
Latches
Wing
Screw
4 places
Push Out