Removing and replacing the blower exit elbow – Country Home Products DR User Manual
Page 42
38
DR
COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions
Removing and Replacing the Blower Exit Elbow
Tool Needed:
Diagonal or wire cutter
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire.
Wing
Screw
4-places
Lift Off
Collector Box Hose
Blower Exit
Elbow Assy
Flexible Latch
Figure 44
Safety
Interlock
Switch
1. Disconnect the Blower Exit Elbow to
the Collector Box Hose by releasing
the two flexible latches (Figure 44) and
separate the hose.
2. Cut the tie around the Inlet Hose at
the end of the Lanyard (Figure 43).
3. Remove the four (4) Wing Screws
from the Blower Exit Elbow Assembly
(Figure 44).
4. Lift the Blower Exit Elbow Assembly
from the top of the Blower and install
a new assembly in the reverse order
(Figure 44).
5. Install the new cable tie through the
end loop of the Lanyard about halfway
along the Blower Inlet Hose.
6. Check the Safety Interlock Switch to
be sure that it is engaged.
Note: If the safety interlock switch is not
engaged, adjust the switch
mounting bracket by loosening the
bracket bolt and sliding the bracket
up so that the button on the switch
is fully depressed against the
blower exit elbow assembly. See
page 16.
Angle
Adjusting
Wing Screw
2 places