Compex Technologies WP11A+ - Manual (Page 71)

Chapter 9 Configuring Network Address Translation
61
3. Click on “IP Forwarding” button.
Figure 9.4b Adding New NAT IP address Entry
Enter the information in the respective parameter fields, for example:
Private IP Address: 192.168.168.40
Public IP Address: 203.100.10.99
4. Click add button to add the address into the IP address-mapping table.
Please note that you must enable the NAT function in the Configuration window if
you are using a single IP address account (fixed static IP) and want to share this
connection on your LAN.
By default, NAT status is set to Enable. Disabling NAT function is to be set only
when you want to a block public IP address from ISP.
To disable NAT, select Disable and press Apply.