Maintenance – Craftsman 286.25574 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION cont.
ATTACHING REPLACiMENT BLADESTOTHE SAW cont, (See Figs. 16 -19)
7. Place the pin (included with the wrench) into tie lined up holes.
8
. Tighten tie lock nut clockwise with the wrench and then remove the pin from the
blades (see Fig, 19). This will allow the blades to turn freely.
9. Carefully turn blades wlti your hand to be sure they easily turn in opposite
directions.
MAINTENANCE
GENERAL
A
w
ARNING:
To avoid accidents, ALWAYS disconnect the tool from the
ppwer source BEFORE cleaning or performing any maintenance.
All parts represent an important part of the double Insulalion system and should be
serviced only at a Sears Service Center.
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use
Use clean cloths to remove dirt, carbon dust, etc.
A
WARNING:
DO NOT at any time let brake fluids, gasoline, petroleum-based
pjoducts, penetrating oils, etc. to come in contact with plastic parts.. They contain
chemicals that can damage, weaken or destroy plastic.
19
5-25-06