Craftsman 286.25574 - Manual (Page 4)

SAFETY INSTRUCTIONS coni.
PERSONAL SAFETY
1. ALWAYS stay alert, watch what you are doing and use common sense when
operating a power toot. DO NOT use tool while tired or under the influence of
drugs, alcohol, or medication. A moment of inattention while operating power
tools may result in serious personal Injury,
2. ALWAYS dress properly. DO NOT wear loose clothing or jewelry. Pull back
long hair. Keep your hair, clothing, and gloves away from moving parts.
Loose clothes, jewelry, or long hair can be caught in moving parts,
3. ALWAYS avoid accidental starting. BE SURE switch Is in the “OfP' position
before plugging in. DO NOT carry tools with your finger on the switch. Carrying
tools with your finger on the switch or plugging in tools that have the switch in the
"Orr“ position Invites accidents.
4. ALWAYS remove adjusting keys or wrenches before turning the tool "On".
A wrench or a key that is left attached to a rotating part of the tool may result in
personal injury.
5. DO NOT overreach. ALWAYS keep proper footing and balance at all times.
Proper tooting and balance enables better control of the too! in unexpected
situations.
6. ALWAYS use safety equipment. Always wear eye protection. Dust mask,
non-skid safety shoes, hardhat, or hearing protection must be used for appropriate
conditions.
TOOL USE AND CARE SAFETY
1. ALWAYS use clamps or other practical ways to secure and support the
workpiece to a stable platform. Holding the work by hand or against your body
is unstable and may lead to loss of control.
2
. DO NOT force the tool. Use the correct too! for your application. The correct
too! will do the Job better and safer at the rate for which it is designed,
3. DO NOT use the tool if the switch does not turn it "On” or‘‘OfF’. Any too! that
cannot be controlled with the switch is dangerous and must be repaired,
4. ALWAYS disconnect the plug from the power source before making any
adjustments, changing accessories or storing the tool. Such preventive safety
measures reduce the risk of starting the tool accidentally
5. ALWAYS store idle tools out of the reach of children and other untrained
persons. Tools are dangerous in the hands of untrained users,
6. ALWAYS maintain tools with care. Keep cutting tools sharp and clean.
Properly maintained tools with sharp cutting edges are less likely to bind and are
easier to control,
7. ALWAYS check for misalignment or binding of moving parts, breakage of
parts, and any other condition that may affect the tool’s operation. If
damaged, have the tool serviced before using. Many accidents are caused by
poorly maintained tools.
A WARNING; USE OF ACCESSORIES THAT ARE NOT RECOMMENDED
FOR USE WITH THIS TOOL MAY CREATE A HAZARDOUS CONDITION
8. ALWAYS use only accessories that are recommended for this tool.
Accessories that may be suitable for one tool can become hazardous when used
on another tool. ^
4