Fasten the header bracket to the wall, Installation step 2 – Craftsman 139.53674SRT User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Step 2
Install the Header Bracket
You can attach the header bracket either to the
wall above the garage door, or to the ceiling.
Follow the instructions which will work best for
your particular requirements.
Fasten the Header Bracket to the Wall
• Center the bracket on the vertical guideline with
the bottom edge of the bracket on the horizontal
tine as shown (with the arrow pointing toward the
’ Mark either set of bracket holes (do not use the
holes designated for ceiling mount). Drill 3/16* pilot
holes and fasten the bracket securely to a structural
> Extend the vertical guideline onto the ceiling as
shown.
' Center the bracket on the vertical mark, no more
than 6" from the wall. Make sure the arrow is
pointing toward the wall. The bracket can be
mounted flush against the ceiling when clearance
is minimal.
' Mark holes designated for ceiling mount only. Drill
3/16* pilot holes and fasten bracket securely to a
structural support with the hardware provided.
Celling Mounting Holes
The nal hole is lor positlonirtg only.
You nwst use leg screws lo mount
the header bracket
14