Craftsman 139.53674SRT - Manual (Page 5)

One-Piece Door Without Track
Before you begin, survey your garage area to
see whether any of the conditions below apply
to your Installation.
Gap batwean floor and bottom
of door must not exceed 1/4’.
Safety Reversing Sensor
Based on your pEtrticular requirements, there are
several installation steps which might call for
materials and/or hardware not included in the carton.
• Step 1, page 13 - Look at the wall or ceiling above
the garage door. The header bracket m ust be
securely fastened to structural supports.
• Step 5, page 17 - Do you have a finished ceiling in
your garage? If so, a support bracket and
additional fastening hardware (not provided) may
be required.
• Safety reversing sensor, page 21 - Depending on
garage construction, wood blocks may need to be
securely fastened to mounting locations before
sensors are installed.
• Step 10, page 22 - Alternate floor mounting of the
safety reversing sensor will require hardware that
is not provided.
• Step 11, page 25 - Generally, a one-piece door
does not require reinforcement. If your door is
lightweight, you can refer to the information
relating to sectional doors on page 24.
• Step 11, page 25 - Depending on your door's
construction, you might need additional mounting
hardware for the door bracket.
• Do you have an access door in addition to the
garage door? If not. Model 53702 Emergency
Key Release is required. See page 38.
> The gap between the bottom of the garage
door and the floor cannot exceed 1/4”.
Otherwise, the safety reverse system may not
work properly. See page 30. The floor or the door
should be repaired.
You may find it helpful to refer back to this page as
you proceed with the Installation of your opener.