Installation step 4 – Craftsman 139.53674SRT User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Step 4
Position the Opener
Follow instructions which apply to your door
type as Illustrated.
To prevent damage to steel, aluminum,
fiberglass or glass panel doors, do not rest the
opener on the door without using a 2x4.
A 2x4 laid flat is convenient for setting an ideal
door-to-T-rail distance.
• Raise the opener onto a steptadder.
you
will need help at this point if the ladder is
not tall enough.
•
Open the door all the way and place a 2x4 laid flat
on the top section beneath the T-rail.
It the top panel hits the trolley when you raise
the door, pull down on the trolley release arm to
disconnect the Inner and outer sections. The
trolley can remain disconnected until Step 12 Is
completed.
xv.'>Av.:o-sv.c.:
. Ki-v S -s. fe
• With the door fully open and parallel to the floor,
measure the distance from the floor to the top of
the door.
• Using a stepiadder as a support, raise the opener
to the same distance as the door from the floor (it
will be at a slight angle as shown).
• The top of the door should be level with the top of
the opener. Do not position the opener more than
2’ above this point.
16