Craftsman 247.885500 - Manual (Page 12)

IMPORTANT: Keep all grease and oil off of the
friction wheel and the drive plate.
Shifting Mechanism
• Lubricate the shifting mechanism and pivot
points on the shift rod with engine oil at least
once a season or after every 25 hours of
operation.
Traction Drive Control
• Lubricate cams on the ends of the control rods
which interlock the traction drive and auger
controls at least once a season or every 25
hours of operation with grease. The cams can be
accessed beneath the handle panel.
Gear Case
• The gear case is lubricated with grease at the
factory and does not require checking. If
disassembled for any reason, lubricate with two
ounces of Shell Alvania grease.
Bearings
• Once a season lubricate the auger bearings and
the bearings on the side of the frame with light
oil. See lube chart below.
Check V-belts
Follow the instructions below to check the condition
of the drive belts every 50 hours of operation.
• Remove the plastic belt cover on the front of the
engine by removing two self-tapping screws.
• Visually inspect for frayed, cracked, or
excessively worn out belts.
Check Friction Wheel
Follow the instructions below to check the condition of
the friction wheel rubber every 25 hours of operation.
•
Remove the four self-tapping screws from the
frame cover underneath the snow thrower.
• Visually inspect the friction wheel rubber for
excessive wear, cracks, or loose fit on the
friction wheel drive hub.
• Also engage traction drive control and check if
the friction wheel is making contact with the
friction plate.
• If it does not make contact, adjust the traction
drive cable following instructions page 11 and
page 20. Recheck the friction wheel.
• Replace friction wheel rubber if necessary.
Refer to instructions on page 22.
18