Using built-in flash, Auto rewind – Nikon Camera F50 User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using Built-In Flash
Use the built-in flash not only when the ready-
light blinks, but also when your subject is in
shadow or baeklit.
See pages 51 to 55.
V
j
Auto Rewind
When the film reaches the end of the roll, auto
rewind begins. During rewinding, Q and blink
in the LCD panel. After rewind automatically
stops, frame counter shows
E
and
Q
blinks for a
few seconds. You can then remove film
cartridge.
• When battery power is very weak, or when the
temperature is very low, film may not rewind at
the end of roll; Err appears in the LCD panel. In
this case, replace battery with a fresh one, or
wait for the temperature to rise and then press
the rewind button.
To rewind film at mid-roll: Press the rewind
i^^utton at the bottom of the camera.
^